- 7 -
2.1 Introduction
This manual has been complied not only for the care and maintenance of DMEGA
suction system now in your possession, but as a helpful reference and guide to prevent
many problems which can occur if used improperly.
2.2 Intended Use:
This product generates compressed air and supplies it directly to the dental unit chair,
or to provide compressed air for use with medical devices such as pneumatically
operated hand-pieces.
2.3 Unpacking
Carefully remove the machine from the shipping case. Preserve all paper work for
future reference. If damage has occurred from shipment a Claim must be filed with the
carrier immediately; preserve the shipping carton for inspection by the carrier. If you are
required to communicate with your dealer or DMEGA, be sure to include your order
numbers for quick identification.
2.4 Mounting
Rubber feet are attached to the product. Rubber feet are excellent for applications
involving a semi-flexible surface such as bench top; they help to isolate noise and
eliminate creeping. However, the horizontal position of the motor shaft should be
preferred.
2.5 Installation Location
The compressor system should be located preferably in a clean, dry and well-ventilated
area. Please be sure not to block the ventilation ports located on the motor housing.
The unit should be placed where the surrounding temperature remains between 10°C
and 40°C (50°F and 104°F). Always check to insure the location chose is protected
from direct or indirect moisture contact.
------------------------------------------ ----------------------------------------
Do not operate the compressor in an atmosphere containing flammable or
explosive gases /vapors. To avoid the risk of electric shock, this equipment must
only be connected to supply mains with protective earth.
SECTION 2. INSTALLATION NOTES
To Next Page
Loading...