DMP Electronics CellComRT - Page 4

Digital Monitoring Products CellCom Installation Guide
4
CellCom System Messages
ThefollowingmessagesarecommunicatedtotheDMPSCS-1RreceivertoindicateCellComstatus:
130WARNING:CellCommunicatorBusFailed
COMMUNICATIONSECURITYFEATURE
The communication on the bus between the panel and the cellular communicator has failed while no areas of
the system were armed. This message may originate from both the panel and the cellular communicator as both
monitorthebus.TherestoralmessageisS132.
131ALARM:CellCommunicatorBusFailed
SERVICENOTIFICATIONFEATURE
The communication on the bus between the panel and the cellular communicator has failed while any area of the
system was armed. This message may originate from both the panel and the cellular communicator as both monitor
thebus.TherestoralmessageisS132.
132CellCommunicatorBusRestored
SERVICENOTIFICATIONFEATURE
The communication on the bus between the panel and the cellular communicator has restored. Message is sent
fromthepaneltothereceiverandisarestoralforS130andS131.
133WARNING:CellCommunicatorDCFailed
SERVICENOTIFICATIONFEATURE
The panel has received a message from the cellular communicator that its input DC voltage is missing or low. The
cellularcommunicatorisoperatingfromitsinternalbattery.TherestoralmessageisS134.
134CellCommunicatorDCRestored
SERVICENOTIFICATIONFEATURE
The panel has received a message from the cellular communicator that its input DC voltage has restored. This
messageisarestoralforS133.
135WARNING:CellCommunicatorLowBattery
SERVICENOTIFICATIONFEATURE
The panel has received a message from the cellular communicator that the cellular communicator’s standby
batteryislowormissing.TherestoralmessageisS136.
136CellCommunicatorBatteryRestored
SERVICENOTIFICATIONFEATURE
The panel has received a message from the cellular communicator that the cellular communicator’s standby
batteryhasrestored.ThismessagerestoresS135.
137WARNING:CellCommunicatorTamper
SECURITYFEATURE
Thepanelhasreceivedamessagefromthecellularcommunicatorthatthecellularcommunicator’sbuilt-in
tamper circuit was placed in an open condition while no areas of the system were armed. The restoral message is
S139.
138ALARM:CellCommunicatorTamper
SECURITYFEATURE
Thepanelhasreceivedamessagefromthecellularcommunicatorthatthecellularcommunicator’sbuilt-in
tamper circuit was placed in an open condition while one or more areas of the system were armed. The restoral
messageisS139.
139CellCommunicatorTamperRestored
SECURITYFEATURE
Thepanelhasreceivedamessagefromthecellularcommunicatorthatthecellularcommunicator’sbuilt-in
tampercircuitwasrestoredtoanormalcondition.ThismessageisarestoralforS137andS138.
AllthemessagesabovearecommunicatedbytheXR100/XR500controlpanelexceptS130andS131Cell
CommunicatorBusFailwhichissentbyboththepanelandCellCom.Forcompleteinformation,refertotheHost
CommunicationSpecication(LT-0086).