Do not put anything on top of the appliance, the airflow will be disrupted and
affects the hot air frying result.
USING THE APPLIANCE
The oil-free can prepare a large range of ingredients.
Hot air frying
1. Connect the mains plug into an earthed wall socket.
2. Put the ingredients in the basket. (Fig.5)
3. Carefully pull the pot out of the Hot-air fryer (Fig.6)
4. Close the door (Fig.7)
Noting to carefully align with the guides in the body of the fryer.
Never use the pot without the basket in it.
Caution: Do not touch the pot during and some time after use, as it gets very
hot. Only hold the pot by the handle.
5.Determine the required preparation time for the ingredient ( see section ‘Settings’ in
this chapter).
6.Some ingredients require shaking halfway through the preparation time (see section
“Settings” in this chapter). To shake the ingredients, pull the pot out of the appliance by
the handle and shake it. Then slide the pot back into the air fryer
caution: Do not press the release button on the handle during shaking. (Fig.3)
Tip: To reduce the weight, you can remove the basket from the pot and shake the
basket only. To do so, pull the pot out of the appliance, place it on a heat-resistant
surface and press the button of handle. and lift the basket out of the pot
Tip: If you set the timer to half the preparation time, you hear the timer buzzer when
you have to shake the ingredients. However, this means that you have to set the timer
again to the remaining preparation time after shaking.
7. When you hear the timer buzzer, the set preparation time has elapsed. Pull the pot out
of the appliance
Note: You can also switch off the appliance manually. To do this, set the time to 1.
Tip: You can adjust temperature or time according to your taste during use. Your
settings will be kept for about 10 mins after you pull the pot out of the body.
8. Check if the ingredients are ready.
If the ingredients are not ready yet, simply slide the pot back into the appliance and
set the timer to a few extra minutes.
To Next Page
Loading...