DMTech BTi100 - Page 29

English
29
6. Power/Standby Indicator LED: Once the Bluetooth speaker is
turned on, the LED will be lit in GREEN. The LED changes to red
colour once the speaker enters standby mode. The speaker goes
into standby mode aer a few minutes of no signal or acvity in
order to save power.
7. AUX (AUDIO IN/USB/SD Input) Indicator LED: The LED will be lit
when the input mode is AUDIO IN, USB or SD.
8. Bluetooth Indicator LED: When the Bluetooth speaker is set to
Bluetooth input, the LED will be lit.
9. USB port: Insert a USB sck to the USB port. Press INPUT unl
the AUX IN LED is blinking. The Bluetooth speaker will detect
MP3 les and and start music playback from USB.
10. SD slot: Insert an SD card in the SD slot. Press INPUT unl AUX IN
LED is blinking. The Bluetooth speaker will detect MP3 les and
start playback from SD card.
11. Input: Input mode is inially set to USB/SD when powered on.
Press INPUT to change the input/playback mode. The input order
is Bluetooth, USB, SD, AUDIO IN.
12.
Press to skip tracks backward. The key cannot control AUDIO IN.
13.
Press to skip tracks forward. They key cannot control AUDIO IN.
14.
Press to play or pause. The key cannot control AUDIO IN.