DMTech BTi100 - Bluetooth and Pairing

English
31
Bluetooth and Pairing
• Press the INPUT buon to switch to Bluetooth input. The
Bluetooth indicator LED will start blinking, to indicate that the
Bluetooth speaker has entered pairing mode. Make sure that
Bluetooth is acvated on the transming Bluetooth device (such
as smartphone, tablet or computer), then go into the Bluetooth
sengs of the transming Bluetooth device and search for
BTi100 and connect with the input pass code ‘0000’. The
Bluetooth speaker will make a sound once the devices have been
successfully paired. The LED will stop blinking and will instead be
stacally lit.
• If BTi100 cannot be found, try to turn Bluetooth o and on again
on the Bluetooth device. Switch the Bluetooth speaker input
mode from Bluetooth to AUX and back again by pressing the
input buon. Try pairing again.
• If the Bluetooth signal is weak, the Bluetooth speaker will
automacally aempt to re-connect with your device. Otherwise
follow above steps to pair again manually.
• The Bluetooth speaker will automacally connect with the
paired device. If you want to pair with another device, turn o
Bluetooth or disconnect from the paired device.