Need help?Do you have a question about the DNA Professional CM4-DSP and is the answer not in the manual?
XLR/Jack combo input for connecting microphones to the mixer.
Adjusts input signal level for microphones and other input devices.
Adjusts the treble level on each channel.
Adjusts the midrange level on each channel.
Adjusts the bass level on each channel.
Adjusts the level of effect added to the corresponding channel.
Controls the volume of an individual channel.
Compatible with phone RCA plugs and 600 ohm line level devices.
Potentiometers for adjusting the timbre of channel 5/6.
Controls the volume of channel 5/6.
Adjusts the volume of the headphones.
Adjusts the depth of the output effect.
Regulates the level of transmitted effect.
Selects signal source for channel 5/6 between line input or player.
Enables/disables Phantom power for all microphone channels.
Main signal outputs using 6.3 mm jack connectors.
Stereo output for connecting headphones.
Connects a separate USB source for media playback.
For inserting compatible devices with media files.
Buttons for play/pause, track selection, and volume adjustment.
Selects playback modes (USB, BLUE, LOD, ONE, ALL) for Bluetooth.
Adjusts signal timbre at specific frequencies (63Hz to 6.3kHz).
Shows the number of the currently selected effect.
Indicates signal level; CLIP indicates distortion.
Selects and confirms effects and their parameters.
Adjusts the volume level for left and right main channels.
Connects the mixer to the power supply via an IEC cable.
Turns the mixer on or off.
Guidelines on proper recycling and disposal of used electrical equipment.
General| Type | DJ Mixer |
|---|---|
| Channels | 4 |
| EQ | 3-Band EQ per channel |
| USB | Yes |
| Inputs | 4 phono/line, 2 mic |
| Outputs | Master, Booth, Record |
| Effects | Built-in DSP effects |
| Weight | 5 kg |
To Next Page