Before use
Remove any packing material and loose parts from unit.
Check the accessories before use. It should be fit with the machine and your purpose.
If the machine is new, the battery must first be charged.
Attention!
After long time storage, the battery capacity will be reduce.
Battery is housed in the handle, press the battery retention clips, and remove battery
from handle.
A substantial drop in operating period per charge indicates that the battery is worn
out and must be replaced.
Battery charger
The power voltage supply must conform to that specified on the rating plate of the
rapid charger.
Always inspect battery charger, cord and plug before use.
Always have damage repaired by a qualified professional.
Protect battery charger against humidity and operate only in dry areas.
The supplied charger is suitable for charging batteries only.
Charging the battery
To start the charging process plug the charger into the battery, then plug in the
battery charger to the main
The battery and charger become warm during the charging process, this is normal.
After termination of the charging process, pull charger plug out of mains socket
unplug charger from battery.
LED indicator on charger: red indicator: charging.
green indicator: charge finished.
About the charger
Disconnect the feeding before connecting or disconnecting the battery
The charger must be used only with rechargeable battery. Never use un-
rechargeable battery.
Do not expose the charger to rain or water
On/Off Trigger
To switch on: press safety button (5) first and hold, then press on/off switch.
To switch off: release the on/off switch
To install cutting blade:
1. Rotate the blade clamp and keep
2. Insert the blade
3. Loose the blade clamp
4. Pull on blade to make sure it is securely fastened.
To Next Page
Loading...