DNA TOOLS-00165 - Advanced Cutting Techniques; Plunge Cutting Procedure; Plunge Cutting Safety Warning; Maintenance and Storage

9
tool. Use only enough pressure to keep the saw cutting.
Plunge Cutting
Clearly mark the line of cut. From a convenient starting point within the cut out area,
place the tip of the blade over that point with saw parallel to the line of cut. Slowing
lower the saw until the button edge of the shoe rests on the workpiece. Start the saw
and allow it to attain full speed. With the saw resting on the shoe, slowly let the saw
forward to lower the blade onto the cut line. Continue this motion until the saw blade
is perpendicular to the workpiece.
WARNING: Make sure the blade does not touch the workpiece until the saw
reaches its max speed. Failure to comply could cause loss of control and result in
serious injury.
MAINTENANCE
Always remove the battery before carrying out any work on the machine.
Care and cleaning
Keep the ventilation openings clear and clean the product regularly. Clean the
housing only with a damp cloth-do not uses any solvents! Dry thoroughly afterwards.
Caution!
If something unusual occurs during use, switch off the tool and remove the battery.
Inspect and repair the tool before using it again. Repair of the tool must only be
carried out by a qualified repair technician.
Repair or maintenance by unqualified personnel can lead to a risk of injury.
Use only identical spare parts for repairing a tool.
Caution!
Ensure that the batteries are charged using the correct charger recommended by the
manufacturer.
Attention!
After long time storage, the battery capacity will be reduce.
In order to maintain battery capacity, we recommend that only store full charged
batteries and top-up the charge from time to time. They should be stored in a dry and
frost-free place, the ambient temperature should not exceed 40
0
C.
STORING
Store the machine, operating instructions and where necessary the accessories in
the original packaging. In this way you will always have all the information and parts
ready to hand.
Pack the device well or use the original packaging in order to avoid transit damage.
Always keep the machine in dry place.