Need help?Do you have a question about the doble F6150 and is the answer not in the manual?
General| Brand | doble |
|---|---|
| Model | F6150 |
| Category | Power Supply |
| Language | English |
Outlines the organization of the user guide into chapters and appendices.
Explains font conventions and definitions used within the manual for clarity.
Provides essential safety guidelines for operating the F6150 instrument.
Describes the internal components of the F6000 instrument.
Explains the ProTesT software system for protective relay testing.
Details the components and connections on the instrument's front panel.
Explains how to set up the instrument and establish communications.
Details the seven-column table for configuring source parameters like amplitude and phase.
Explains how to vary source values using ramp or set modes.
Configures logic inputs, outputs, timers, and notes through various tabs.
Provides readouts for eight timers used for timing tests.
Explains how to save current Control Panel setups to .f6x files.
Guides through setting up and performing a pickup test on an overcurrent relay.
Guides through performing a time test using timers and phase angles.
Explains how to rotate faults between phases without rewiring.
Guides through setting up and performing a reach test on a distance relay.
Directs users to diagnostic flow charts for identifying and isolating problems.
Offers external checks to isolate problems before removing the unit's cover.
Explains status LEDs on various circuit boards for diagnostic purposes.
Lists procedures for troubleshooting specific components like power supply and I/O boards.
Offers steps to resolve issues with communication between the F6150 and ProTesT.
Categorizes errors into Hardware, Source, and System errors.
Details steps required before replacing any component, including cover removal.
Provides instructions and illustrations for removing the instrument's outer cover.
Details the procedure for replacing internal circuit boards in the F6150.
Explains the steps for replacing the battery simulator and cooling fans.
Lists part numbers for field replaceable items.
Lists essential guidelines for the safe operation of the F6150 instrument.
Provides contact details for support and instructions for safe instrument packing.
Explains the use of the Flash Loader for installing revised firmware.
Details how to check and change communication settings for firmware updates.
Describes the utility for installing options using software keys.
Provides instructions for connecting the control PC via Ethernet.
Guides on configuring PC network settings and instrument IP address.
Details rules for selecting and paralleling voltage and current sources.
Explains compliance voltage and provides tables for range settings.
Lists and illustrates various pre-configured source setups.
Explains how GPS synchronizes multiple F6150s for end-to-end testing.
Details the required equipment and setup for GPS synchronization.
Explains waveform building at 10 kHz sample rate and rounding function impact.
Defines accuracy specifications for ambient conditions.
Provides procedures for checking amplitude and THD for various sources.
Details procedures for testing phase shift on current and voltage sources.
Lists source configurations and ranges for voltage/current sources.
Covers source operation, immunity, surge capability, accuracy, and noise.
Lists safety standards, EMC compliance, enclosure material, and dimensions.
To Next Page
