5
T:25℃/ 200℃
B:25℃/ 60℃
Function
2.5 3D Print Functional Module Control Interface
Return
Preheat heated bed: For testing
whether the bed heating is normal,
press again to stop heating
Preheat nozzle: For testing whether
the nozzle heating is normal, press
again to stop heating
Filament feed button: For installing
filament and testing extrusion
performance, provided that the nozzle
is preheated to about 200ºC
Filament retraction button: For
removing filament, provided that the
nozzle is preheated to about 200ºC
Cooling fan switch: For detecting
whether the cooling fan is normal
Set heated bed preheat
target temperature
Set nozzle preheat
target temperature
Move
1 mm0.06 mm 10 mm
2.7 X/Y/Z Motion Control Interface
Step distance switching buttons
Return
Reset X/Y/Z axis linear actuators
(Not available for MOOZ-3)
Reset all linear actuators, the
corresponding operations will not
change any settings
Control motion of X/Y/Z, the
corresponding operations will not
change any settings
Settings
2.8 Other Settings Interface
Switch languages
Calibrate the LCD touch screen
Restore factory settings
Return
1 mm0.06 mm 10 mm
X: 20 Y: 20 Z: 20
0 mm
Zeroing
2.6 Zero Point Setting Interface
Fine tuning value for Z-axis zero point,
That is, when the zero point is higher,
it is set to a negative value, and when
the zero point is lower, it is set to a
positive value.
Zero point updating
X/Y/Z motion control buttons
Return
Display current coordinates
Step distance switching buttons:
It should be used along with motion
control buttons, indicating the moving
distance of linear actuators when the
button is pressed (0.06mm/1mm/10mm)
To Next Page
Loading...