4. Apply Filter Oil:
○
Using Mopar Performance Air Filter Service Kit
P5153376 spray oil evenly along the crown of
each filter pleat holding the nozzle about 3”
(76 mm) away.
○
With one good coat of oil let it wick (saturate)
for about 20 minutes, then if required, touch up
any light areas on either side of the air filter
until there is a uniform red color on all areas.
VEHICLE AND TIRE STORAGE
If the vehicle is to be stored over the winter or for long
periods of time, it is highly recommended to first flush
the fuel system of high ethanol content by filling and
driving the vehicle with premium gasoline until the
instrument cluster shows less than 12% ethanol.
NOTE:
•
Do not allow tires to be stored in a room less than
15°F (-9°C).
•
If vehicle is stored with tires mounted, lift vehicle or
pump tires up to max sidewall pressure. Please note
that tire pressure increases as the ambient tem-
perature increases.
CARBON FIBER WHEEL —
IF EQUIPPED
Wheel Center/Carbon Fiber Rim Disassembly
CAUTION!
Do not tighten, loosen, or remove rim fasteners. Tam-
pering with rim fasteners will void warranty.
Tire Pressure Transmitter
Removing Tire Pressure Transmitter from Wheel
1. Mark each tire pressure transmitter using a paint
pen with the transmitter position (Left Front, Right
Front, Left Rear, Right Rear).
2. Remove the valve and pressure transmitter assem-
bly from the wheels using the manufacturer’s rec-
ommended removal instructions.
Installing Pressure Transmitter On Preinstalled Carbon
Fiber Wheel Valve
The carbon wheel comes with a new valve preinstalled
and properly torqued
NOTE:
Do not tighten the preinstalled valve retention nut.
1. Use the provided torque-head screw to attach the
pressure transmitter to the preinstalled valve.
2. Using the space provided, position the sensor on the
valve so the left and right edges of the pressure
transmitter contact the wheel rim.
3. Hold the pressure transmitter by hand while tighten-
ing the torque-head screw.
NOTE:
Tighten the torque-head screw to 9.0 N·m (80 in-lb ).
4. After tire installation, install the provided thumb
screw cap.
Tire Mounting
Mount the tire using conventional tire mounting equip-
ment. Tire mounting should be performed by a qualified
professional.
NOTE:
A non-contact tire mounting machine is preferred to
help reduce the risk of damaging the wheel finish.
Use soapy water, or equivalent, to lubricate the tire
bead as needed.
NOTE:
Standard adhesive-back wheel weights may be used.
Correct Wheel Rim Contact
Incorrect Wheel Rim Contact
MAINTENANCE 27
4
To Next Page
Loading...
