Voice Command Button
When you press the Voice Command
button you will hear a BEEP. The beep is your
signal to give a command.
The Uconnect威 Phone can be used with any Hands-Free
Profile certified Bluetooth威 mobile phone. See the
Uconnect威 website for supported phones. Refer to your
mobile service provider or the phone manufacturer for
details.
The Uconnect威 Phone is fully integrated with the vehi-
cle’s audio system. The volume of the Uconnect威 Phone
can be adjusted either from the radio volume control
knob or from the steering wheel radio control (right
switch), if so equipped.
The radio display will be used for visual prompts from
the Uconnect威 Phone such as “Phone” or caller ID.
Operation
Voice commands can be used to operate the Uconnect威
Phone and to navigate through the Uconnect威 Phone
menu structure. Voice commands are required after most
Uconnect威 Phone prompts. You will be prompted for a
specific command and then guided through the available
options.
•
Prior to giving a voice command, one must wait for
the beep.
•
For certain operations, compound commands can be
used. For example, instead of saying “Setup”, “Device
Pairing” and then “Pair a Device”, the following
compound command can be said: “Setup”, “Device
Pairing” and “Pair a Bluetooth威 Device”.
•
For each feature explanation in this section, only the
compound form of the voice command is given. You
can also break the commands into parts and say each
part of the command when you are asked for it. For
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119
To Next Page
Loading...
Need help?
General
