Speed Control
When engaged, the Speed Control takes over ac-
celerator operations at speeds greater than
25 mph (40 km/h).
To Activate
Push the on/off button. To turn the system off,
push the on/off button a second time. The system
should be turned off when not in use.
To Set A Desired Speed
Turn the Speed Control on. When the vehicle has
reached the desired speed, push the SET button
and release. Release the accelerator and the
vehicle will operate at the selected speed.
To Deactivate
A soft tap on the brake pedal, pushing the
CANC button, or normal brake pressure while
slowing the vehicle will deactivate Speed Control
without erasing the set speed memory. Pushing
the on/off button or turning the ignition switch
OFF erases the set speed in memory.
To Resume Speed
To resume a previously set speed, push the
RES button and release.
To Increase Speed
When the Speed Control is set, you can increase
speed by pushing the SET (+) button.
To Decrease Speed
When the Speed Control is set, you can decrease
speed by pushing the SET (-) button.
To Accelerate For Passing
Press the accelerator as you would normally. When
the pedal is released, the vehicle will return to the
set speed.
For further information and applicable warnings
and cautions, please refer to your Owner’s Manual
at www.dodge.com/en/owners/manuals.
Speed Control Switches
1 — Push Cancel
2 — Push Set+/Accel
3 — Push Resume
4 — Push On/Off
5 — Push Set-/Decel
SPEED CONTROL
To Next Page
Loading...
