170 STARTING AND OPERATING
The ignition must be in the ON/RUN
mode for a shift to take place and for the
position indicator lights to be operable.
If the ignition is not in the ON/RUN mode,
the shift will not take place and no posi-
tion indicator lights will be on or flashing.
A flashing NEUTRAL (N) position indicator
light indicates that shift requirements
have not been met.
6. Using a ballpoint pen or similar object, push
and hold the recessed transfer case
NEUTRAL (N) button (located by the selector
switch) for one second.
NEUTRAL (N) Switch
7. When the NEUTRAL (N) indicator light turns
off, release the NEUTRAL (N) button.
8. After the NEUTRAL (N) button has been
released, the transfer case will shift to the
position indicated by the selector switch.
9. Shift the transmission into PARK and turn
the engine off.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
15. Shift the transmission into REVERSE or
DRIVE, release the brake pedal, and check
that the vehicle operates normally.
DRIVING TIPS
ON-ROAD DRIVING TIPS
Utility vehicles have higher ground clearance
and a narrower track to make them capable
of performing in a wide variety of off-road
applications. Specific design characteristics
give them a higher center of gravity than
conventional passenger cars.
An advantage of the higher ground clearance is
a better view of the road, allowing you to
anticipate problems. They are not designed for
cornering at the same speeds as conventional
passenger cars any more than sports cars are
designed to perform satisfactorily in off-road
conditions. Avoid sharp turns or abrupt
maneuvers. As with other vehicles of this type,
failure to operate this vehicle correctly may
result in loss of control or vehicle rollover.
21_WD_OM_EN_USC_t.book Page 170
To Next Page
Loading...
Need help?
General
