GETTING TO KNOW YOUR VEHICLE 85
STOWING THE CROSSBARS
1. Starting with one crossbar, completely
loosen the thumb screws at both ends.
Slide the crossbar away from the matching
letter to remove it from the deployed
position. Repeat with the other crossbar.
2. Starting with the one crossbar, bend up the
pivot supports at each end.
Crossbar Pivot
3. Position the crossbar along the correct side rail.
Make sure the letters on the crossbar align with
the matching letters on the side rail.
Stowing Crossbars
4. Slide the crossbar outward, away from the
center of the roof. The crossbar will nest
fully within the side rail.
Crossbar To Side Rail
5. Once the driver’s side crossbar is in place,
tighten the thumb screws completely.
Tightening Crossbar
CAUTION!
Use care when removing and handling the
crossbars to prevent damage to the vehicle.
2
21_WD_OM_EN_USC_t.book Page 85
To Next Page
Loading...
