For US and 110-120 volt power supply countries you must use two different power cords (each
plugged into a separate outlet), one for each control box! Each line current can only handle 15 Amp
and peak power consumption of the two combined boxes can be more than your breaker can handle,
resulting in the breaker to fail, if this happens you will have to reset your breaker to this part of the
house.
2.2 BALANCING – This is a critical step to get the best performance and lifespan from your platform!
When all is moving and working, and you have mounted all your game controllers on the platform,
try to make sure the extra weight is balanced over the platform around the Center Of Gravity
under the center of the platform. If you add weight on one side (e.g. front right) the opposite
side (rear left) must be loaded with more weight in order to counterbalance.
0) it works only for 6 DOFs now. If your platform was delivered on or before 2020, we will need to update your
firmware . Email to sales@dofreality.com
1) you close SRS and disable PC Bluetooth before starting it.
Unzip and run balancing app https://dofreality.com/balance.zip
2) click Connect and when connected you should see two ports in the boxes under the buttons
3) wait 10 sec and click Balance . get inside your seat after 10 sec delay (to let you get into the seat etc) you
will hear ding sound and your platform will move up and down. When done you will hear another ding sound.
During motions app might be unresponsive.
4) you will see recommendations on the screen WHERE to move weight and the number telling how much to
move. the number is not in pounds or kilos, but rather relative units.
5) you move your body only to the mentioned direction. temporary , just to see the results. It might be
inconvenient to stay this way , but we just testing it now. and click Balance again .
6) platform will move and give you new results ON THE TOP of the old ones.
7) when you get perfect or almost perfect balancing position move the seat and other objects on your platform
and retest it with your normal sitting position until your get balancing done.
We strongly advise against adding weight in this fashion, as this adds unnecessary weight for the motors to lift
while changing directions. The best counter-balance is your own weight, which is governed by the seat position.
If one or multiple motors are overheating (or even getting hot) during use this is might mean that one side of
the platform is overloaded and you need to move some structural weight away from that side. The motors
should NEVER be hot! Overheated magnets inside the motor loose power forever and it leads to substantial
motor power decrease.
To Next Page
Loading...
Need help?
General
