Dogtra StB-Hawk - Dogtra StB-Hawk Operation; Operating Modes Explained; Charging the Batteries

28 29
Dogtra StB-Hawk OPERATION
The Dogtra StB-Hawk always starts in Run/Point mode. To
activate the unit, place the activation magnet to the red dog of the
beeper collar and hold them for a second. The collar will beep
twice after a power-on melody.
The beeper collar will sound every 7 seconds while the dog is
running, and every 2 seconds when the dog is gone on point or
become stationary in a Run/Point mode.
To select a Point Only mode, place activation magnet to the red
dot of the beeper collar for 0.5 to 1 second and release them (First,
beeper collar has to turned on.). The collar will emit a hawk sound
as the mode switched to Point Only.
The beeper collar will remain silent while the dog is running and
emit the hawk or beep sound every 2 seconds when the dog is on
point or stationary.
Mode Dog Running Dog Pointing
Run/Point
mode
Double beep
every 7 seconds
Double beep every 2 seconds
Only Point
mode
Silence Hawk or Beep sound every 2 seconds
CHARGING THE BATTERIES
'RJWUD6W%+DZNXVHVDOLWKLXPSRO\PHUEDWWHU\
&KDUJHWKHXQLWIRUKRXUVEHIRUHXVLQJWKHXQLWIRUWKH¿UVW
time.
'RQRWFKDUJHWKHEDWWHU\QHDUDQ\ÀDPPDEOHVXEVWDQFHV
3. Fully charge the battery if the unit is to be stored without use
for a period of 3 months or more.
Recharge the unit if :
• The indicator light is red or does not come on.
220 volt
Charger
Wall Outlet