Dolmar ET-120 C - User Manual

Questions and Answers

J
jonescarolynAug 2, 2025
Why is my Dolmar Trimmer vibrating abnormally?
- M
  Monica HarrisAug 2, 2025
  Abnormal vibration in your Dolmar Trimmer can occur due to several reasons. It may be caused by a broken nylon cord. To resolve this, bump the nylon cutting head against the ground while it is rotating to cause the cord to feed. Another cause could be a bended, cracked, or worn cutter blade, which requires replacement. Also, check if the cutter blade fastening nut is loose and tighten it properly as described in this manual. For issues related to the drive system, it is recommended to ask your local authorized service center for repair.
M
Michelle DunnAug 7, 2025
What to do if the cutting tool of my Dolmar ET-120 C Trimmer does not rotate?
- C
  Charles HernandezAug 7, 2025
  If the cutting tool of your Dolmar Trimmer doesn't rotate, a foreign object might be jammed between the guard and the cutting tool; remove it. Also, the cutter blade fastening nut might be loose, so tighten it properly as described in this manual. If the cutter blade is bended, replace it. If these steps don't resolve the issue, the drive system may not be working correctly, and you should ask your local authorized service center for repair.
A
Anthony HensleyAug 12, 2025
How to fix a Dolmar ET-120 C Trimmer when the motor does not run?
- J
  Justin JamesAug 12, 2025
  If the motor of your Dolmar Trimmer does not run, first ensure that the power mains is properly plugged in. If the power cable is broken or the drive system isn't working correctly, it's best to ask your local authorized service center for repair.
E
ephelpsAug 18, 2025
What to do if the cutting tool and motor of my Dolmar ET-120 C won't stop?
- J
  joshua72Aug 18, 2025
  If the cutting tool and motor of your Dolmar Trimmer cannot stop, disconnect the mains plug immediately. This could be due to an electric or electronic malfunction, in which case, you should disconnect the mains plug and ask your local authorized service center for repair.
L
larsonbrianAug 22, 2025
Why does my Dolmar ET-120 C motor stop running after a little use?
- K
  Karen GriffithAug 22, 2025
  If your Dolmar Trimmer's motor stops running after a short period, it may be due to overheating. Stop using the tool and allow it to cool down.
R
robert54Aug 27, 2025
Why my Dolmar ET-120 C Trimmer does not reach maximum RPM?
- S
  Sara MarquezAug 27, 2025
  If your Dolmar Trimmer does not reach maximum RPM, the drive system may not be working correctly. Ask your local authorized service center for repair.