What to do if my Dolmar ET-71 C motor does not run?
If the Dolmar Trimmer motor isn't running, first, ensure the power cord is properly plugged into the mains. If the issue persists, the power cable may be broken or the drive system may not be working correctly, in that case you should ask your local authorized service center for repair.
What to do if the cutting tool of my Dolmar ET-71 C Trimmer does not rotate?
If the cutting tool of your Dolmar Trimmer doesn't rotate, stop the machine immediately and check for any foreign objects, like a branch, jammed between the guard and the nylon cutting head. Remove any obstruction. If there is no visible obstruction, the drive system may not be working correctly, in that case you should ask your local authorized service center for repair.
Why is my Dolmar Trimmer vibrating abnormally?
If your Dolmar Trimmer is vibrating abnormally, stop the machine immediately. One possible cause is that one end of the nylon cord has broken. Try bumping the nylon cutting head against the ground while it is rotating to cause the cord to feed. If the vibration persists, the drive system may not be working correctly, in that case you should ask your local authorized service center for repair.
Why does my Dolmar ET-71 C Trimmer motor stop after a little use?
If the motor of your Dolmar Trimmer stops running after a short period of use, it may be overheating. Stop using the tool and allow it to cool down.
What to do if the cutting tool and motor of my Dolmar ET-71 C Trimmer cannot stop?
If the cutting tool and motor of your Dolmar Trimmer cannot be stopped, disconnect the mains immediately. This could be due to an electric or electronic malfunction. Disconnect the mains and ask your local authorized service center for repair.
To Next Page
General
