10
Attachment of shoulder harness (Fig. 9)
Adjusttheharnesslengthsothatthecuttingtooliskept
parallelwiththeground.
Connectthehangerandtheharness.
WARNING:
• Be extremely careful to maintain control of the tool
at all times. Do not allow the tool to be deected
toward you or anyone in the work vicinity.Failureto
keepcontrolofthetoolcouldresultinseriousinjuryto
thebystanderandtheoperator.
Adjustment of the hanger position and shoulder
harness (Fig. 10)
To change the hanger position, loosen the bolt on the
hanger.Thenmovethehanger.
Afteradjustingthehangerposition,tightentheboltwith.
MAINTENANCE
WARNING:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance on the tool. Failure to switch off
andunplugmayresultinserious personalinjuryfrom
accidentalstart-up.
NOTICE:
• Never use gasoline, benzine, thinner, alcohol or the
like.Discoloration,deformationorcracksmayresult.
Replacing the nylon cord (Fig. 11)
WARNING:
• Make sure that the nylon cutting head is secured to
the tool properly before operation.Failuretoproperly
securethenyloncuttingheadmaycauseittoyapart
resultinginseriouspersonalinjury.
1. Remove the lock screw by turning it
counterclockwise.
2. Removethespoolandthecup.Andremovetheold
nyloncordfromthespool.
3. Cutanyloncordin3–6m.Foldthecuttingcordin
twohalves, leave oneofhalf longer 80–100 mm
thananother.(Fig. 12)
4. Hookthemiddleofthenewnyloncordtothenotch
locatedatthecenterofthespoolbetweenthetwo
channelsprovidedforthenyloncord.(Fig. 13)
5. Wind both ends rmly along the channels in the
directionindicatedbyarrowmarkonthespool.
6. Install the nylon cutting head as described in this
instructionmanual.(Fig. 14)
To maintain product SAFETY and RELIABILITY,
repairs,anyothermaintenanceoradjustmentshouldbe
performedbyDolmarAuthorizedServiceCenters,always
usingDolmarreplacementparts.
To Next Page
Loading...
