Dolmar ET-71 C - Maintenance Interval; Troubleshooting

11
MAINTENANCE INTERVAL
Parts: Interval: Howto:
Powercord Everytimebeforeuse
Visuallyinspectwhetheritisnotbadlywornordamaged.
Ifitisdamaged,askyourlocalservicecenterforrepair.
Auxiliaryhandlescrew Everytimebeforeuse
Checkwhetherscrewisnotloose.Tightenthescrewifit
isloose.Replacethescrewifitisdamaged.
Cuttingtoolguard
(protector)
Everytimebeforeuse
Checkwhetherscrewisnotloose,whetherprotectoris
notdamaged.Tightenthescrewifitisloose.Replacethe
protectorifitisdamaged.
Nyloncuttinghead Every10h
Visuallyinspectwhetheritisnotbadlywornordamaged.
Ifitisdamaged,replaceit.
TROUBLESHOOTING
Beforeaskingforrepairs,conductyourowninspectionrst.Ifyoundaproblemthatisnotexplainedinthemanual,do
notattempttodismantlethetool.Instead,askDolmarAuthorizedServiceCenters,alwaysusingDolmarreplacement
partsforrepairs.
Malfunctionstatus Cause Action
Motordoesnotrun.
Powermainsisnotpluggedin. Pluginthemains.
Powercablebroken.
Ask your local authorized service
centerforrepair.
The drive system does not work
correctly.
Motorstopsrunningafteralittleuse. Overheating.
Stopusingoftooltoallowittocool
down.
ItdoesnotreachmaximumRPM.
The drive system does not work
correctly.
Ask your local authorized service
centerforrepair.
Cuttingtooldoesnotrotate:
stopthemachineimmediately!
Foreign objectsuch asa branchis
jammedbetweentheguardandthe
nyloncuttinghead.
Removetheforeignobject.
The drive system does not work
correctly.
Ask your local authorized service
centerforrepair.
Abnormalvibration:
stopthemachineimmediately!
Oneendofthenyloncordhasbeen
broken.
Bumpthenyloncuttingheadagainst
the ground while it is rotating to
causethecordtofeed.
The drive system does not work
correctly.
Ask your local authorized service
centerforrepair.
Cuttingtoolandmotorcannotstop:
Disconnectthemainsimmediately!
Electricorelectronicmalfunction.
Disconnectthemainsandaskyour
local authorized service center for
repair.
OPTIONAL ACCESSORIES
CAUTION:
• Theseaccessories orattachmentsare recommended
forusewithyourDomartoolspeciedinthismanual.
Theuseofanyotheraccessoriesorattachmentsmight
presentariskofinjurytopersons.Onlyuseaccessory
orattachmentforitsstatedpurpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar Service
Center.
• Nyloncuttinghead
• Nyloncord(cuttingline)
• Shoulderharness
NOTE:
• Some items in the list may be included in the tool
packageasstandardaccessories.Theymaydifferfrom
countrytocountry.