Dolmar MS-251 - Mounting of Protector; Protector Installation Instructions

]
GB |
Mounting of protector A
To meet the applicable safety provisions. only the tooliprolecior combination as indicated in the table must be used
|
Ee
ve
eeh
|
MS-220, MS-250, MS-2200, MS-2500 Be sure to use genuine MAKITA cutter blade or nylon cutting head. |
jenes aaa c *The cutter blade must be well polished, free of cracks or breakage. i
rotactor for :
Protector for Metal Blade Hi the cutter blade hits against a stone during operation, stop the
Star Blade ` Metal Cutter for Me : o uring op
(Guard Speciicatione for Both engine and check the blade immediately.
lade and Cord Cutts) | Polish or replace the cutter blade every three hours of operation
> * The ouiside diameter ot the cutter blade must be 230 mm (9-1/16")
Never use any blades surpassing 230 mm (9-1/16") in outside
diameter.
i i
Gross
Pestutre
Part
No.
:
Part 98004003 (MS-220MS-250) — i
208804 400 98028002 E SCH |
ка: {
i MS-221, MS-251,MS-2201,MS-2501 —
| кыд Se =
Í муюп Cuting Protector for расою Nyon Cutting Hoad |
| Head Nylon Cutting pecifications
Head metal biade and cord cutter)
| a >
| IR
|
] g |
i Part No.
| PartNo Part No. -221MS-
LT-250 ]
Nylon cutting head Protector for nylon cutting head
жу, i
=
Part No. 6168011001 Part No. 6168006001
CAUTION
The appropriate protector must always be installed, for your own safety and in order to comply with accident-prevention regulation:
Operation of the equipment without the guard being in place in not permitted. []
= For MS-2200 , MS-2500 , MS-2201, MS-2501
MS-220 , MS-250 , MS-221, MS-251
*
Install
the
clamp
(3)
on
the
drive
shaft
so
that
the
projection
of}
the clamp (3) is inserted into the opening between the gear сазе!
1 (1) and the shaft. !
|
Secure
the
protector
(4)
with
the
installation
bolts
M6
x
30
(2)
14