Dolmar PS-220 TH User Manual (English)

Other manuals for Dolmar PS-220 TH

Questions and Answers:

M
matthewleeAug 10, 2025
What to do if my Dolmar Chainsaw engine does not start?
- A
  Alejandro BrightAug 10, 2025
  If your Dolmar Chainsaw engine isn't starting or starts with difficulty, several factors could be at play. You should check the ignition spark and ensure the fuel tank is adequately filled. Inspect the wiring for any faults or short-circuits. Also check the choke position and inspect the carburetor. Clean the suction head and inspect the fuel line for bends or interruptions. Inspect the crankcase gasket, radial shaft packings, cylinder or piston rings. Check the spark plug seal. Finally, replace any broken spring in the starter or check for broken parts inside the engine.
L
linda60Aug 15, 2025
Why does my Dolmar PS-220 TH Chainsaw have insufficient power?
- J
  Jocelyn SolomonAug 15, 2025
  Insufficient power in your Dolmar Chainsaw can stem from a few key issues. The air filter might be dirty, so clean or replace it. The carburetor may need adjustment. A clogged muffler or exhaust channel in the cylinder could also be the cause, so unclog the muffler and check the exhaust channel.
W
westchaseAug 21, 2025
How to fix warm start difficulties with my Dolmar PS-220 TH?
- S
  Sandra ValenzuelaAug 21, 2025
  If you're experiencing warm start difficulties with your Dolmar Chainsaw, the carburetor adjustment may be incorrect. Adjust the carburetor to resolve this issue.
E
Elizabeth WilliamsAug 26, 2025
Why is there no chain lubrication on my Dolmar Chainsaw?
- A
  Angel WallerAug 26, 2025
  If your Dolmar Chainsaw isn't lubricating the chain, the oil tank might be empty, so refill it. Alternatively, the oil guide groove could be dirty; in this case, clean the oil guide groove.
Z
Zachary JonesAug 31, 2025
What to do if my Dolmar PS-220 TH starts, but dies immediately?
- A
  Angela HayesAug 31, 2025
  If your Dolmar Chainsaw starts and then immediately dies, it could be due to several reasons. Try adjusting the idling. Also, the suction head or carburetor might be dirty, so clean them. Another cause could be a defective tank venting, which you should fix. Finally, inspect and repair the fuel line, cable, or STOP switch if they are defective.
H
Heather BrownSep 4, 2025
What to do if the chain does not run on my Dolmar Chainsaw?
- D
  dennis91Sep 4, 2025
  If the chain on your Dolmar Chainsaw isn't running, it's likely that the chain brake is actuated. Release the chain brake to allow the chain to run.