Dolphin 12V25A - Technical Specifications; Mains Power Characteristics; Battery Charger Characteristics

NOT_AIO.PREMIUM-01
NOT_AIO.PREMIUM-01
TECHNICAL SPECIFICATIONSSAFETY PRECAUTIONS
EN
Free electrolyte
scanning charge
Boost = 14,4V
Float = 13,2V
Sealed lead-acid
scanning charge
Boost = 14,2V
Float = 13,6V
Lead-calcium
scanning charge
Boost = 14,8V
Float = 13,8V
Delphi
scanning charge
Boost = 15,4V
Float = 13,8V
Spiral cell agm
Boost.1 = 14,8V
Boost.2 = 15,5V
Float = 13,8V
Winterizing
Boost = 14,4V
Weekly automatic
Float = 13,2V
Gel
scanning charge
Boost = 14,4V
Float = 13,8V
Power supply Float = 13,6V
AC auxiliary output characteristics
Number of outputs 2
Voltage Same as mains power voltage
Frequency Same as mains power frequency
Max. current 10A
Protection 10A magnetic thermal circuit breaker
General
Operating T° -10°C to +55°C
Storage T° -20°C to +70°C
Relative humidity Max. 90% (without condensation)
Convection Forced (thermostat-controlled fan)
Standards EN61000-6-1, EN61000-6-3, EN60335
Case Wall-mounted in painted aluminium alloy
Mounting By 3 screws (diameter 4 mm)
Dimensions
(mm) 395 x 188 x 103 mm
Weight < 3 kg
Mains power connector Type WINSTA (WAGO), 2 x 2,5 mm
2
AC output connector Type WINSTA (WAGO), 2 x 2,5 mm
2
Battery connector Type PC6/4 (Phoenix Contact), 4x16 mm
2
4In the event of damage to the AC or DC cables, these
latter should only be replaced by authorised personnel, in
order to avoid danger.
4Mains power and batteries must be disconnected
(cable, connectors and/or main switches).
4Wait 5 min. before starting work on the case to allow
the high voltage capacitors to discharge.
4Battery fuses should only be replaced by fuses of
identical specication and ratings.
Code 399121 399123
Mains power characteristics
Voltage 230V +/- 10%
Frequency 50 - 60Hz +/- 10%
Charger
consumption
2,5A 4,0A
Auxiliaries
consumption
Max. 10A total for both outputs
Display LED on front panel (yellow)
Differential circuit
breaker
16A 30mA
Charger fuse T6,3A T10A
Display On/Off LED on front panel (yellow)
Battery charger characteristics
Voltage 85V - 265V
Frequency 50 - 60Hz
+/- 10%
Number of outputs 3 isolated outputs
Charging rates Total 8
Charge selector Toggle switch inside case
12V25A 12V40A
Voltage tolerance +/- 2%
Ripple < 1%
Max. current 25A +/- 5% 40A +/- 5%
-DC fuse F30A 2 x F30A
Protection
By fuse, in the event of internal overhea-
ting, abnormal output voltage, output
short-circuit or reverse polarity
Display
3-colour LED on front panel
Yellow: Boost mode
Green: Float mode
Red: Fault