WARRANTY
IN ORDER TO ENSURE THAT THE UNIT IS PROPERLY
USED, CAREFULLY READ THE LIST OF INCIDENTS
OR POTENTIAL DEFECTS NOT COVERED BY THE
WARRANTY
4Dropping the unpackaged unit can
permanently distort the case, and/or cause
the failure of the internal cooling fan or certain
electronic components.
4Modications to the case (particularly drilling
additional holes) can leave swarf or metal lings
on the electronics board, causing malfunctions or
permanent damage to the unit.
4Work or modications on the electronics board
can result in operating modes for which the unit
was not designed, causing permanent damage
to the unit.
4Connecting the unit to a power supply outside
tolerances (generally an excessive mains power
voltage) can cause permanent damage to the
unit.
4Accidental mains power overvoltage or a
lightning strike generally causes permanent
damage to the unit.
4Replacing battery fuses by fuses with different
ratings can cause permanent damage to the
unit.
4Obvious connection errors causing permanent
damage to the unit.
4Water spray or run-off water inside the unit can
cause permanent electronic malfunctions.
Important: Note concerning the charging rate.
Using a charging cycle that is unsuitable for the
battery technology may seriously damage the
battery.
This is particularly the case when using a
charging voltage signicantly greater than that
recommended by the battery manufacturer.
A considerable risk of battery overheating, with
a release of noxious gases that can damage
health.
Refer to the manufacturer’s recommendations to
determine the correct charging cycle.
Precautions for scrapping
This unit contains electronic components and
materials that must be recycled at the end of the
unit’s life cycle, for environmental reasons.
At the end of their life cycle, all units should be
either returned to the local distributor or entrusted
to a specialist electronic equipment recycling
company.
WARRANTY
EN
To Next Page
Loading...
