AZ motor Edition 4
Instructions for bearings replacement 2
1. ABOUT INSTRUCTIONS FOR BEARINGS REPLACEMENT
In this document there are presented steps for safe bearings replacement in AZ motors. Every
step is described with text and pictures so that any kind of misunderstanding is minimized to a
low level.
Before any kind of motor disassembly you should read the instructions for bearings
replacement first.
During the bearings replacement you will need some standard and specially adjusted tools.
The list of tools is described in chapter 1.2.
Some parts of the motor must not be used again. The list of new motor parts is described in
chapter 1.3.
All pictures in this document are symbolic.
Domel d.o.o is not responsible for any kind of equipment damage, motor or EC controller
failure or any kind of personal injuries or material damage that were caused because of not
following the instructions for bearings replacement.
1.1 Explanation of safety signs and safety messages
Bellow there is presented the explanation of safety signs which are used in these instructions.
For your safety and safety of your equipment you should always follow safety signs.
DANGER indicates a hazardous situation with a high level of
risk.
WARNING indicates a hazardous situation with a medium
level of risk.
CAUTION indicates a hazardous situation with a low level of
risk.
NOTE.
Notes, additional information and instruction tips.
To Next Page
Loading...
