Dometic 2-WAY ELITE RM4872 User Manual

7
11.11.
11.11.
11.
12 12
12 12
12
VV
VV
V
OLOL
OLOL
OL
T DC CONNECTIONT DC CONNECTION
T DC CONNECTIONT DC CONNECTION
T DC CONNECTION
This refrigerator model is not designed for 12 volt DC
operation of the cooling system; however, 12 volt DC must
be supplied to the refrigerator to operate the controls. Use
a
minimum of a 14 gauge wireminimum of a 14 gauge wire
minimum of a 14 gauge wireminimum of a 14 gauge wire
minimum of a 14 gauge wire between the battery and
refrigerator to supply the control voltage. The connection
is made to the positive (+) and negative (–) terminals of the
terminal block on back of refrigerator. (See FIG. 6) The 12
volt DC supply circuit must be fused, and the
maximummaximum
maximummaximum
maximum
fuse size is 5 ampfuse size is 5 amp
fuse size is 5 ampfuse size is 5 amp
fuse size is 5 amps.
DO NOTDO NOT
DO NOTDO NOT
DO NOT use the chassis or vehicle frame as one of the
conductors. Connect two wires at the refrigerator and
route to the DC supply.
Clean Direct Current (DC) power is mandatory forClean Direct Current (DC) power is mandatory for
Clean Direct Current (DC) power is mandatory forClean Direct Current (DC) power is mandatory for
Clean Direct Current (DC) power is mandatory for
high-tech circuits to operate as designed. The sourceshigh-tech circuits to operate as designed. The sources
high-tech circuits to operate as designed. The sourceshigh-tech circuits to operate as designed. The sources
high-tech circuits to operate as designed. The sources
for DC power are a battery and a converter.for DC power are a battery and a converter.
for DC power are a battery and a converter.for DC power are a battery and a converter.
for DC power are a battery and a converter.
A battery will provide straight line DC power, butA battery will provide straight line DC power, but
A battery will provide straight line DC power, butA battery will provide straight line DC power, but
A battery will provide straight line DC power, but
extended operation will require recharging of theextended operation will require recharging of the
extended operation will require recharging of theextended operation will require recharging of the
extended operation will require recharging of the
battery by the converter or the alternator.battery by the converter or the alternator.
battery by the converter or the alternator.battery by the converter or the alternator.
battery by the converter or the alternator.
The converter and alternator produces DC power by aThe converter and alternator produces DC power by a
The converter and alternator produces DC power by aThe converter and alternator produces DC power by a
The converter and alternator produces DC power by a
series of diodes that rectify alternating current to DC.series of diodes that rectify alternating current to DC.
series of diodes that rectify alternating current to DC.series of diodes that rectify alternating current to DC.
series of diodes that rectify alternating current to DC.
A battery or capacitors can be used to clean up the ACA battery or capacitors can be used to clean up the AC
A battery or capacitors can be used to clean up the ACA battery or capacitors can be used to clean up the AC
A battery or capacitors can be used to clean up the AC
ripple that is present after AC voltage has been recti-ripple that is present after AC voltage has been recti-
ripple that is present after AC voltage has been recti-ripple that is present after AC voltage has been recti-
ripple that is present after AC voltage has been recti-
fied.fied.
fied.fied.
fied.
12.12.
12.12.
12.
INSTRINSTR
INSTRINSTR
INSTR
UCTION FOR INSTUCTION FOR INST
UCTION FOR INSTUCTION FOR INST
UCTION FOR INST
ALLINGALLING
ALLINGALLING
ALLING
DOOR PDOOR P
DOOR PDOOR P
DOOR P
ANELANEL
ANELANEL
ANEL
The refrigerator is normally delivered without the door
panels. Before starting the mounting work, check that the
panel dimensions are in compliance with those given in the
Table on this page and the instructions are read thor-
oughly. When mounting the panel, proceed as follows.
(See FIG. 8)
A. Remove the trim strip from the door by taking out the
3 screws. See FIG. 8.
B. Locate the 2 pins in the end frame of the door. If they
are in the top frame, relocate the pins into the holes
in the bottom door frame to support the panel. See
FIG. 8.
C. Slide panel into grooves on vertical edges of the door
until it slips into the groove on the opposite end of
door.
D. Replace trim strip and screws.
FIG. 8FIG. 8
FIG. 8FIG. 8
FIG. 8
Refr. Models HEIGHTRefr. Models HEIGHT
Refr. Models HEIGHTRefr. Models HEIGHT
Refr. Models HEIGHT
WIDTH WIDTH
WIDTH WIDTH
WIDTH
TYPETYPE
TYPETYPE
TYPE
MAX.MAX.
MAX.MAX.
MAX.
MIN.MIN.
MIN.MIN.
MIN.
MAX.MAX.
MAX.MAX.
MAX.
MIN.MIN.
MIN.MIN.
MIN.
RM4872RM4872
RM4872RM4872
RM4872
upper mm 403 400 527 524
inch 15-7/8 15-3/4 20-3/4 20-5/8
lower mm 987 984 527 524
inch 38-7/8 38-3/4 20-3/4 20-5/8
PANEL DIMENSIONSPANEL DIMENSIONS
PANEL DIMENSIONSPANEL DIMENSIONS
PANEL DIMENSIONS
MAX. THICKNESS 5/32" (4 mm)MAX. THICKNESS 5/32" (4 mm)
MAX. THICKNESS 5/32" (4 mm)MAX. THICKNESS 5/32" (4 mm)
MAX. THICKNESS 5/32" (4 mm)
13. CHANGING DOOR SWING TO
OPPOSITE SIDE
The refrigerator is equipped with convertible doors.
To change the door swing, consult the parts manual
for the Conversion Kit Part Number. For further
information, please contact the Dometic Corpora-
tion listed on the front page.

Dometic 2-WAY ELITE RM4872 Specifications

General

Brand	Dometic
Model	2-WAY ELITE RM4872
Category	Refrigerator
Language	English