9
2.2.
2.2.
2.
CONTRCONTR
CONTRCONTR
CONTR
OL POL P
OL POL P
OL P
ANELANEL
ANELANEL
ANEL
FIG. 10FIG. 10
FIG. 10FIG. 10
FIG. 10
LEGEND 2-WAY MODELLEGEND 2-WAY MODEL
LEGEND 2-WAY MODELLEGEND 2-WAY MODEL
LEGEND 2-WAY MODEL
1. Main Power Button ON/OFF
2. AUTO/GAS Mode Selector Button
3. TEMPERATURE Selector Button
A. AC Mode Indicator Lamp
B Auto Mode Indicator Lamp
C Gas Mode indicator lamp
D Check Indicator Lamp (Gas Mode Only)
E Temperature Indicator Lamps
J Climate Control Switch
JJ
JJ
J
ON
OFF
AUTO
AC GAS
11
11
1
22
22
2
CHECK COLD 1 2 3 4 5 COLDEST
33
33
3
BB
BB
B
CC
CC
C
AA
AA
A
EE
EE
E
DD
DD
D
2-WAY DISPLAY PANEL2-WAY DISPLAY PANEL
2-WAY DISPLAY PANEL2-WAY DISPLAY PANEL
2-WAY DISPLAY PANEL
3.3.
3.3.
3.
STST
STST
ST
ARAR
ARAR
AR
TT
TT
T
-UP INSTR-UP INSTR
-UP INSTR-UP INSTR
-UP INSTR
UCTIONSUCTIONS
UCTIONSUCTIONS
UCTIONS
Before starting the refrigerator, check that all the manual
gas valves are in the ON position. DO NOT forget the
manual shutoff valve on the rear of the refrigerator. See
FIG. 6.
This refrigerator is equipped with a control system, which
can automatically select the most suitable energy source
which is available, either AC or LP gas operation. The
system can be set by the user to be fully automatic, or if
desired, LP gas only.
A. A 12 volt DC supply must be available for the elec-
tronic control to function. The refrigerator controls will
work down to 9.6 volts DC.
B. Press the main power ON/OFF button (1) to the
DOWN position.
C. Press the TEMPERATURE SELECTOR BUTTON
(3) until the lamp at the desired setting is illuminated.
A. AUTO MODE
Press the Auto mode selector button (2) to the DOWN
position. Lamp (B) will illuminate. If 120 volts is
available, the AC mode indicator lamp (A) will illumi-
nate indicating AC operation. If 120 Volts AC is not
available, the GAS indicator lamp (C) will illuminate,
indicating the control has automatically switched to
the GAS mode.
If the CHECK indicator lamp (D) illuminates and the
GAS mode indicator lamp (C) is off, the controls have
failed to ignite the burner in the GAS mode. GAS
operation may be reset by pressing the main power
ON/OFF button (1) to the OFF then ON position. (See
Step 2 under GAS MODE).
Press the TEMPERATURE SELECTOR button (3)
until the lamp at the desired position is illuminated.