Dometic 310 - Operation

7
Dometic Model 310 ToiletInstallation / Operation / Cleaning
3. Verify that oor ange seal is installed on base of toilet (g.
5
A, page 2). Carefully set toilet
over oor ange. Align holes in toilet base with T-bolts as toilet is lowered onto oor ange.
Toilet must be aligned so that outlet of base ts inside of oor ange outlet hole.
Note
Entire toilet base does not rest completely on oor yet. Floor seal must be compressed in
following steps.
4. Install oor mounting nuts and washers onto T-bolts. Carefully torque nuts to 30-40 inch-
pounds. DO NOT OVERTIGHTEN. Alternate between sides when tightening to prevent
distortion of base. When tight, base should be securely attached and at against oor.
Attach bolt covers onto nuts. (Fig.
5
B, page 2)
5. If toilet is being installed in a shower stall, apply a bead of caulk around base of toilet to prevent
water seepage under base.
6. Connect water supply line and torque connection to 30-40 inch-pounds.
DO NOT OVERTIGHTEN. (Fig.
5
C, page 2)
7. Turn on water supply line. Flush toilet several times and check for leaks.
7 Operation
7.1 Add water to bowl
To add water to the toilet, press the ush pedal
part way down. Water ows into the bowl while
ush ball remains closed. If the ush ball moves,
let up on the pedal slightly. Adding water to an
empty bowl helps prevent holding tank odors from
entering the living space. Adding water is recom-
mended prior to ushing solids and toilet paper.
7.2 Flush toilet
To ush, press pedal down until it contacts the
oor. Release pedal after complete ush.
• When ushing liquids, press the pedal for 1-2 seconds.
• When ushing solids, press pedal until contents are rinsed from bowl. Flushing longer than
necessary will cause holding tank to ll too quickly.
A small amount of water will collect in the bowl after a ush to create an airtight seal.
Note
Residual water trickle in ceramic bowls: Due to integrated rim of models 310, 311, 320
and 321 toilets, water may continue to trickle into toilet bowl for up to 20 minutes after
ushing. If water trickle continues after 30 minutes, replace water valve.
Note
To ensure holding tank odors do not enter the living space, make sure 1 inch (24 mm) of
water remains in the toilet bowl. Because of variations in plumbing systems and user
operation, the “add water” function may be required to achieve the 1-inch water depth.
Flush directions are located under
toilet seat lid.