Dometic 59016.521 - Precautions; Warnings and Safety Guidelines

To Next Page

To Previous Page

2.2.

PRECAUTIONSPRECAUTIONS

PRECAUTIONS

ARNINGARNING

ARNING

IMPROPER INSTALLATION MAY DAMAGE EQUIP-IMPROPER INSTALLATION MAY DAMAGE EQUIP-

IMPROPER INSTALLATION MAY DAMAGE EQUIP-

MENT, COULD ENDANGER LIFE, CAUSE SERIOUSMENT, COULD ENDANGER LIFE, CAUSE SERIOUS

MENT, COULD ENDANGER LIFE, CAUSE SERIOUS

INJURY AND/OR PROPERTY DAMAGE.INJURY AND/OR PROPERTY DAMAGE.

INJURY AND/OR PROPERTY DAMAGE.

A. Read Installation and Operating Instructions carefully

before attempting to start your air conditioner.

B. The Dometic Corporation will not be liable for any

damages or injury incurred due to failure in following

these instructions.

C. Installation must comply with the National Electrical

Code and any State or Local Codes or regulations.

D. DO NOT add any devices or accessories to this air

conditioner except those specifically authorized by

Dometic.

E. This equipment must be serviced by qualified person-

nel and some states require these people to be

licensed.

3.3.

CONTROL DESCRIPTIONCONTROL DESCRIPTION

CONTROL DESCRIPTION

The Dometic Air Conditioner Control is a sophisticated

electronic control using the latest electronic technology.

It consists of a

Comfort Control Center (Part No.Comfort Control Center (Part No.

Comfort Control Center (Part No.

3106363.007)3106363.007)

3106363.007) and an

Electronic Control Box (PartElectronic Control Box (Part

Electronic Control Box (Part

No. 3106481.009No. 3106481.009

No. 3106481.009). The

Comfort Control CenterComfort Control Center

Comfort Control Center is the

operator interface. It contains a liquid crystal display

(LCD) and the operator switches and buttons. The

Electronic Control BoxElectronic Control Box

Electronic Control Box contains the interface circuitry

for the air conditioner.

A.A.

COMFORT CONTROL CENTERCOMFORT CONTROL CENTER

COMFORT CONTROL CENTER

1) The LCD indicates the mode of operation, the

temperature Setpoint and the fan speed.

a. The possible modes of operation are

OFF, FANOFF, FAN

OFF, FAN

ONLY, COOL, FURNACEONLY, COOL, FURNACE

ONLY, COOL, FURNACE and

HEAT STRIPHEAT STRIP

HEAT STRIP.

b. The possible fan speeds are

LOW, MED, HIGHLOW, MED, HIGH

LOW, MED, HIGH

and

AUTOAUTO

AUTO.

c. The temperature

SetpointSetpoint

Setpoint range is 40 to 99

degrees Fahrenheit.

d. In the case of multiple zones, the zone will

indicate

ZONE 1ZONE 1

ZONE 1,

3 or

2) The mode of operation is selected by momentarily

depressing the

MODEMODE

MODE pushbutton.

3) The fan speed is selected by momentarily de-

pressing the

FANFAN

FAN pushbutton.

4) The temperature

SetpointSetpoint

Setpoint is adjusted by momen-

tarily depressing the

upup

up or

downdown

down arrow.

5) An ON/OFF switch is provided on the lower right

edge of the

Comfort Control CenterComfort Control Center

Comfort Control Center.

6) In the event that a

Remote Temperature SensorRemote Temperature Sensor

Remote Temperature Sensor

(Part No. )(Part No. )

(Part No. ) is not used, the

Comfort ControlComfort Control

Comfort Control

CenterCenter

Center temperature sensor is used. In this case,

the

Comfort Control CenterComfort Control Center

Comfort Control Center must be treated as

a wall thermostat and appropriately mounted in

the RV.

7) The

Comfort Control CenterComfort Control Center

Comfort Control Center is connected to the

Electronic Control BoxElectronic Control Box

Electronic Control Box via a 4-conductor tele-

phone cable using telephone RJ-11 connectors.

B.B.

ELECTRONIC CONTROL BOXELECTRONIC CONTROL BOX

ELECTRONIC CONTROL BOX

1) The

Electronic Control BoxElectronic Control Box

Electronic Control Box contains relays for

switching the various fan speeds, compressor and

furnace.

2) There are wires protruding from the

BoxBox

Box for con-

nection to DC power, furnace thermostat wires

and an Energy Management System.

3) A

Freeze Control SensorFreeze Control Sensor

Freeze Control Sensor connects to the

Elec-Elec-

Elec-

tronic Control Boxtronic Control Box

tronic Control Box to allow for the prevention of

freezing coils. This sensor lead is inserted into the

Box and plugged into a connector for that purpose.

4) A

Remote Temperature SensorRemote Temperature Sensor

Remote Temperature Sensor may be con-

nected to the

Electronic Control BoxElectronic Control Box

Electronic Control Box using the

Remote Sensor KitRemote Sensor Kit

Remote Sensor Kit (Part No. 3106486.008).

4.4.

OPERAOPERA

OPERA

TING INSTRTING INSTR

TING INSTR

UCTIONSUCTIONS

UCTIONS

A.A.

FAN ONLY MODE OPERATIONFAN ONLY MODE OPERATION

FAN ONLY MODE OPERATION

1) Place the Power switch to the

ONON

ON position.

2) Momentarily depress the

MODEMODE

MODE pushbutton until

FAN ONLYFAN ONLY

FAN ONLY indicator on the Liquid Crystal Display

(LCD) is illuminated.

Dometic 59016.521 - Precautions; Warnings and Safety Guidelines

Other manuals for Dometic 59016.521

Related product manuals