To Next PageTo Next Page
Need help?Do you have a question about the Dometic 600315.421 and is the answer not in the manual?
Details installation requirements, roof construction, and spacing for RV air conditioners.
Strategies to reduce heat gain in RVs for better AC performance, including parking and window coverings.
Explains condensation formation and how the AC helps manage moisture within the RV.
Emphasizes dangers of improper installation, alteration, or servicing, and liability.
Only Dometic-authorized accessories are permitted; servicing requires qualified personnel.
The operator interface with LCD, buttons, and sensors for mode, fan speed, and temperature settings.
Contains relays for fan, compressor, furnace, and connections for sensors and EMS.
Guides for operating Fan Only, Cooling, Furnace, and Heat Strip modes.
Covers auto fan, compressor delay, power interruption, and zone control functions.
Instructions for cleaning or replacing the air filter to maintain performance.
Basic checks for unit failure, power supply, fuses, and information for service calls.
Mounting guidelines for one/two units, and roof requirements for placement.
Covers roof cavity, discharge area, duct sizing, registers, and return air opening.
Details duct material, insulation, system pressure, and thermostat location.
Installer must review floor plan for duct size, layout, register size, locations, and thermostat position.
Instructions for cutting and framing the 14" x 14" roof and ceiling opening, including warnings.
Instructions for routing power, 12V DC, sensor, furnace, and EMS wiring.
Rules for selecting the Comfort Control Center location, emphasizing height, partition mounting, and avoiding heat/drafts.
Routing and terminating the 4-conductor telephone cable from the roof opening to the control center.
Steps for mounting the base plate and connecting the control cable to the unit.
Instructions for placing the unit on the roof and managing internal components.
How to check gasket alignment, adjust the unit, and pull the electrical cord through the opening.
Adjusting, placing, and insulating the divider plate based on ceiling thickness.
Connecting cables, mounting the box, and installing the freeze sensor.
Connecting remote sensor, 12V DC, furnace, and EMS wires to the control box.
Adjusting dip switches in the control box based on installed options.
Routing the 115 VAC power supply line and connecting wires with strain relief.
Verifying system functions and performing final configuration by pressing UP/DOWN buttons.
Connecting the air conditioner ribbon cable to the thermostat cable connector.
Placing and securing the return air cover to the ceiling template with screws.
Details installation requirements, roof construction, and spacing for RV air conditioners.
Strategies to reduce heat gain in RVs for better AC performance, including parking and window coverings.
Explains condensation formation and how the AC helps manage moisture within the RV.
Emphasizes dangers of improper installation, alteration, or servicing, and liability.
Only Dometic-authorized accessories are permitted; servicing requires qualified personnel.
The operator interface with LCD, buttons, and sensors for mode, fan speed, and temperature settings.
Contains relays for fan, compressor, furnace, and connections for sensors and EMS.
Guides for operating Fan Only, Cooling, Furnace, and Heat Strip modes.
Covers auto fan, compressor delay, power interruption, and zone control functions.
Instructions for cleaning or replacing the air filter to maintain performance.
Basic checks for unit failure, power supply, fuses, and information for service calls.
Mounting guidelines for one/two units, and roof requirements for placement.
Covers roof cavity, discharge area, duct sizing, registers, and return air opening.
Details duct material, insulation, system pressure, and thermostat location.
Installer must review floor plan for duct size, layout, register size, locations, and thermostat position.
Instructions for cutting and framing the 14" x 14" roof and ceiling opening, including warnings.
Instructions for routing power, 12V DC, sensor, furnace, and EMS wiring.
Rules for selecting the Comfort Control Center location, emphasizing height, partition mounting, and avoiding heat/drafts.
Routing and terminating the 4-conductor telephone cable from the roof opening to the control center.
Steps for mounting the base plate and connecting the control cable to the unit.
Instructions for placing the unit on the roof and managing internal components.
How to check gasket alignment, adjust the unit, and pull the electrical cord through the opening.
Adjusting, placing, and insulating the divider plate based on ceiling thickness.
Connecting cables, mounting the box, and installing the freeze sensor.
Connecting remote sensor, 12V DC, furnace, and EMS wires to the control box.
Adjusting dip switches in the control box based on installed options.
Routing the 115 VAC power supply line and connecting wires with strain relief.
Verifying system functions and performing final configuration by pressing UP/DOWN buttons.
Connecting the air conditioner ribbon cable to the thermostat cable connector.
Placing and securing the return air cover to the ceiling template with screws.
General| Brand | Dometic |
|---|---|
| Model | 600315.421 |
| Category | Air Conditioner |
| Language | English |
