To Next PageTo Next Page
Need help?Do you have a question about the Dometic 600312.321 and is the answer not in the manual?
General| Brand | Dometic |
|---|---|
| Model | 600312.321 |
| Category | Air Conditioner |
| Language | English |
Details on intended use, roof mounting, ceiling cavity, and installation requirements.
Strategies to minimize heat gain, including parking, window coverings, and door management.
Explanation of moisture condensation and its management by the air conditioner.
Essential warnings on installation, adjustment, alteration, service, and unauthorized modifications.
Description of the operator interface, LCD display, modes, fan speeds, and temperature settings.
Details on the control box's relays, sensor connections, and interface circuitry.
Instructions for setting the fan speed and operating the unit without cooling or heating.
Steps to select cooling mode, set temperature, and understand compressor cycling.
Guidance on operating the furnace mode, including temperature settings and fan behavior.
Instructions for the electric heat strip mode, fan speed limitations, and operation.
Details on Auto Fan, compressor time delay, power interruption recovery, and zone control.
Procedure for maintaining the return air filter for optimal unit performance and longevity.
Steps to check power, wiring, and fuses before contacting service for non-operational units.
Guidance for positioning a single air conditioner unit, centered and slightly forward.
Recommendations for positioning two air conditioners, at 1/3 and 2/3 points of the RV.
Checking for roof obstructions and acceptable slope for proper installation.
Requirements for roof cavity depth, total duct discharge area, and duct dimensions.
Specifications for register distance, number of registers, and total duct length limits.
Standards for duct materials, R-7 insulation, and joint sealing to prevent condensation.
Minimum return air opening, filtration needs, and acceptable system pressure ranges.
Determining duct size/layout, thermostat location, and preparing for remote sensors or furnace integration.
Step-by-step instructions for cutting the 14x14 opening, including critical safety warnings.
Routing power, low voltage, thermostat, sensor, and EMS wires to the prepared opening.
Rules for positioning the Comfort Control Center and Remote Sensor for optimal performance.
Routing and connecting the 4-conductor telephone cable from the roof to the control center.
Instructions for unpacking and carefully placing the 100 lb. air conditioner unit on the RV roof.
Using the ceiling template for alignment and pulling the electrical cord through for connection.
Positioning the electronic kit, return air cover, and associated hardware inside the RV.
Applying insulation to the divider panel to seal the opening and prevent air leakage.
Adjusting dip switches on the control box for installed options.
Wiring the main power supply to the electronic control box junction box.
Verifying system operation and performing the final configuration procedure.
Attaching the return air cover and grille to the ceiling template using screws.
