OPERATION
Prepare
toilet
for use
1.
/;\CAUTION!
With seat lid closed, pull
4.
Pour deodorant directly into lower tank,
flush handle to open slide valve, then
then close slide valve.
push to close. This relieves air pressure
1
CAUTION! Never pour deodorant into
that may be created in lower holding
A
bowl with slide valve closed.
tank due to changes in temperature or
altitude.
5. Stroke air pump about
15
times or until air
emits through relief valve on water cap.
2. Remove water cap and fill upper tank until
it reaches about
1
inch (25 mm) below
1
CAUTION! Do not over pressurize
opening. Replace cap.
A
upper tank by covering relief valve.
Do not pressurize upper tank when
3.
Pull flush handle to open slide valve.
disconnected from lower tank.
Use
toilet
1.
/C\CAUTION!
BEFORE EACH
USE,
with
2. Pull flush handle to release waste into
seat lid closed, pull flush handle to open
lower tank.
slide valve, then push to close. This
3.
Push flush button to rinse bowl. Push flush
relieves air pressure that may be created
handle to close slide valve.
in lower holding tank due to changes in
temperature or altitude.
Empty
holding
tank
2. Pull up on rear latch to separate upper tank
1.
When tank level indicator shows "full,"
from lower tank. Carry lower tank to autho-
empty the lower tank.
rized waste disposal area (or normal toilet).
If toilet is installed with optional mounting
3.
Rotate discharge spout away from tank,
brackets, pull locking handle from lower
and open vent on top of holding tank.
tank. Lift and move toilet to reach rear latch.
Empty tank.
4.
If water is available, rinse lower tank before
reassembling
portable toilet.
To Next Page
Loading...
Need help?
General