INSTALLATION
BE SURE TO READ INSTRUCTIONS COMPLETELY BEFORE INSTALLATION.
MSD DISCHARGE FITTING FOR DOMETIC
®
970 SERIES
PORTABLE TOILETS
® Registered; ™ Trademark of Dometic Corporation
© Dometic Corporation
600345664-INTL 4/09
Hose ID
Discharge 1.5 inch/ 38 mm
Vent .625 inch/ 16 mm
PLUMBING SPECIFICATIONS
A
Tie-wrap
Discharge elbow adapter
Discharge tting
Vent tting
B
C
Holding
Tank
MSD
Discharge
Fitting
EN
NOTE: Dometic 970 series portable toilet should be permanently
installed with floor mounting brackets (385311564 or 860003853200056)
before installing MSD discharge fitting. Allow 2.75 inches (70 mm) clearance
between back of toilet and wall for MSD discharge fitting.
1.
Remove discharge spout from top of holding tank by turning it
counterclockwise until it unlocks (see illustration A) and pulling it out of
tank.
2. Lubricate two small O-rings on discharge tting with silicone grease and
attach discharge elbow adapter to discharge tting. Secure adapter in
place with plastic tie-wrap (see illustration B).
3. Lubricate large O-ring on discharge tting and insert discharge tting
assembly into holding tank. Rotate it so that discharge and vent
ttings point away from tank (see illustration C).
4. Using hose clamp, attach 1.5-inch (38 mm) ID discharge hose over end
of elbow adapter. Make sure discharge hose(s) connect securely to all
discharge ttings.
5. Using hose clamp, attach 0.625-inch (16 mm) ID vent hose to vent tting.
Make sure vent hose connects securely to through-hull vent tting.
DOMETIC CORPORATION, SANITATION DIVISION
13128 SR 226 | PO BOX 38 | BIG PRAIRIE, OHIO 44611 USA
www.DometicSanitation.com
To Next Page
Need help?
General