4445103622 9
Health hazard
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction con-
cerning use of the appliance in a safe way and
understand the hazards involved.
• Always keep the appliance out of the reach of
children.
• Children must be supervised to ensure that they
don’t play with the device
• Cleaning and user maintenance shall not be
made by children without supervision.
Risk of injury
• Lay the cables so that they cannot be tripped
over or damaged.
Explosion hazard
• Do not operate the device under these circum-
stances:
– Wet or damp environments.
– Vicinity of corrosive fumes.
– Vicinity of combustible materials.
– Risk of gas or dust explosion.
A
NOTE Damage hazard
• Do not expose the device to a heat source (such
as direct sunlight or heating). Avoid additional
heating of the device this way.
• Setup the device in a dry location where it is pro-
tected against splashing water.
• Do not install the device in a dusty environment.
• Make sure that the mounting surface is capable
of supporting the weight of the device.
• Use ductwork or cable ducts if it is necessary to
lay cables through metal panels or other panels
with sharp edges.
• Lay the cables so that they cannot be damaged
by the doors or the bonnet.
• Do not lay the 230 V mains cable and the 12 V
DC cable in the same duct.
• Do not lay the cable so that it is loose or heavily
kinked.
• Fasten the cables securely.
• Do not pull on the cables.
• Always use sockets which are grounded and
secured by residual current circuit breakers.
• Make sure that the lead has a sufficient cross-sec-
tion.
• Make sure the air inlets and outlets of the device
are not covered.
• Ensure good ventilation.
Scope of delivery
Accessories
Target group
All other actions are intended also for non-profes-
sional users.
Quantity Description
1 Pure sine wave inverter
1 Installation and operating manual
2 1.2 m battery cable with M8 lugs.
11.2 m mains cable
1 5 m extension cable with RJ12 plugs for
remote control
1 Extension cable adapter
Description SKU
Fuse set 80 A (for MT600) 9620000210
(MT06080)
Fuse set 175 A (for MT1200) 9620000217
(MT06175)
Fuse set 250 A (for MT1700) 9620000166
(MT06250)
5m extension cable with RJ12 plugs for
remote control
9620000171
(MT02005)
The electrical installation and setup of
the device must be performed by a qual-
ified electrician who has demonstrated
skill and knowledge related to the con-
struction and operation of electrical
equipment and installations, and who is
familiar with the applicable regulations
of the country in which the equipment is
to be installed and/or used, and has
received safety training to identify and
avoid the hazards involved.
To Next Page
Loading...
Need help?
General