Dometic CF SERIES User Manual

EN
CF18, CF25, CF35, CF40, CF50 Operation
17
7.5 Using the cooler
A
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤ Close the cooler, see chapter “Connecting to a battery (vehicle or boat)” on
page 14.
I
CF18
➤ Set the slide switch (fig. 3 4, page 9) to "HIGH" when power is supplied by
your vehicle's starter battery.
➤ Set the slide switch (fig. 3 4, page 9) to "LOW" when power is supplied by an
external DC power supply source.
✓ The “POWER” LED is lit green.
✓ The cooler starts cooling the interior.
✓ When the cooling temperature has been reached, the “POWER” LED is lit yellow.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. The cooler MUST maintain a MINIMUM of 50 mm
away from walls or similar surfaces which could restrict important air flow
requirements of the cooling system.
NOTE
Place the cooler as shown (fig. 1, page 6). If you operate the box in a
different position it can be damaged.
NOTE
If you wish to operate the cooler from the AC power supply, set the
battery monitor to the “LOW” position.
CF18-CF60-O-AUS.book Seite 17 Dienstag, 27. Februar 2018 2:14 14

Dometic CF SERIES Specifications

General

Category	Accessories
Product Depth Dimensions	Undefined
Product Height Dimensions	Undefined
Product Width Dimensions	Undefined
Net weight	Undefined
Input voltage (AC)	Undefined
Input voltage (DC)	Undefined
Rated input power (AC)	Undefined
Rated input power (DC)	Undefined
Refrigerant, type	Undefined
GWP	Undefined
Refrigerant amount	Undefined
CO2 equivalent	Undefined
Energy consumption in Eco mode	Undefined
Climate class (EN62552)	Undefined
Insulation type	Undefined
Series	CF
Capacity	Undefined
Energy Efficiency	Undefined
Warranty	Undefined
Power Source	Undefined