CF50SG Operation
13
6.2 Energy saving tips
•
Choose a well ventilated location which is protected from direct sunlight.
•
If you want to set an increased energy efficiency and a limited cooling capacity for
the cooler device, use the device’s ECO mode.
•
Allow warm food to cool down first before placing it in the cooling device.
•
Do not open the cooling device more often than necessary.
•
Do not leave the cooling device open for longer than necessary.
•
Defrost the cooling device once a layer of ice forms.
•
Avoid unnecessarily low temperatures.
6.3 Connecting the cooler
Connecting to a battery (vehicle or boat)
The cooler can be operated with 12 V
g or 24 Vg.
A
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
Using the fused DC plug
A
➤ Plug the DC connection cable (fig. 1 2, page 7) into the DC power supply inlet
of the cooler (fig. 3 3, page 10).
➤ Connect the connection cable to a DC power outlet.
NOTICE! Danger of damage!
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
NOTICE! Danger of damage!
For protection of the device the DC cable supplied includes a fuse inside
the plug. Do not remove the fused DC plug.
Only use the DC cable supplied.
CF50SG-O-AUS.book Seite 13 Dienstag, 19. Mai 2020 1:06 13
To Next Page
Loading...
