Cleaning and maintenance CFF12, CFF20, CFF35, CFF45, CFF70DZ
28
6.14 Replacing the DC plug fuse
➤ Replace the DC plug fuse as shown in fig. d, page 11.
6.15 Replacing the light PCB
A
7 Cleaning and maintenance
!
A
➤ Occasionally clean the cooling device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
NOTICE! Damage hazard
The lamp can only be replaced by the manufacturer, a service agent or
similarly qualified person to avoid hazard.
WARNING! Electrocution hazard
Failure to obey this warning could result in death or serious injury.
Always disconnect the device from the power supply before you clean
and service it.
NOTICE! Damage hazard
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
To Next Page
Loading...
