Dometic CFF20 - Setting the Temperature; Temperature Setting (Single Compartment); Temperature Setting (Dual Compartment)

EN
Operation CFF20, CFF35, CFF45, CFF70DZ
22
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2, page 10) down, until it latches in place audibly.
I
6.6 Setting the temperature
CFF20, CFF35, CFF45
➤ Press the “SET” button (fig. 3 5, page 11) once.
➤ Use the “UP +” (fig. 3 7, page 11) and “DOWN –” (fig. 3 6, page 11) buttons
to select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
CFF70DZ
➤ Press the “SET” button (fig. 3 5, page 11):
– once for the large compartment
– twice for the small compartment
✓ The chosen compartment‘s display blinks.
➤ Use the “UP +” (fig. 3 7, page 11) and “DOWN –” (fig. 3 6, page 11) buttons
to select the cooling temperature.
Each compartment can be set to work as a refrigerator or a freezer compartment.
✓ The cooling temperature appears in the chosen compartment‘s display for a few
seconds. The display flashes several times and then the current temperature is
displayed again.
NOTE
CFF35, CFF45: When latching the lid, ensure that both latch side pins
are fully engaged to ensure a good lid seal. One latch may engage
slightly before the other.
If the lid is not closed equally at both sides, press until a second click is
heard.
DometicCFF20-35-45-75DZ_OPM_4445103133_APAC(en)_202x-xx-xx.book Seite 22 Dienstag, 20. Oktober 2020 4:16 16