Dometic CFF20 - Switching Off the Cooler; Cooler Shutdown Procedure

EN
Operation CFF20, CFF35, CFF45, CFF70DZ
24
6.8 Setting the display brightness
The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
➤ Switch on the cooler.
➤ Press the “SET” button (fig. 3 5, page 11):
– CFF20, CFF35, CFF45: Four times.
– CFF70DZ: Five times.
➤ Use the “UP +” (fig. 3 7, page 11) or “DOWN –” (fig. 3 6, page 11) buttons to
set the brightness of the display.
✓ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✓ The display shows the set mode for several seconds. The display flashes twice
before it returns to the current temperature.
I
6.9 Switching off the cooler
➤ Empty the cooler.
➤ Switch the cooler off.
➤ Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
➤ Leave the lid slightly open. This prevents odor build-up.
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically reverts to brightness d0
(default). After troubleshooting the set brightness is reactivated.
DometicCFF20-35-45-75DZ_OPM_4445103133_APAC(en)_202x-xx-xx.book Seite 24 Dienstag, 20. Oktober 2020 4:16 16