Dometic DM Series - Page 20

20
EN
Refrigerator
Upper and Lower Plastic Side-By-Side Vent
(No. 3109349.xxx)
17
13-5/8"
28-5/8"
Cutout
➤ Place the frame into the cutout.
➤ Secure the frame with five Z-brackets.
➤ Install six #10 screws (three on each end, not
provided) to completely secure the frame.
➤ Remove the screw cap plugs from the vent frame
and install them over the six screws in the front
frame.
➤ Install the vent door into the frame using the upper
tabs as a guide.
➤ Lock the vent door into place by fully seating and
twisting the black latches in the bottom corners of
the vent door.
Upper and Lower Plastic Side Vent
(No. 3109492.xxx)
18
9-11/16"
19-1/4"
Cutout
➤ Place the frame into the cutout.
➤ Secure the frame with seven Z-brackets using #10
screws (not provided).
➤ Install the vent door into the frame using the upper
tabs as a guide.
➤ Lock the vent door into place by fully seating and
twisting the black latches in the bottom corners of
the vent door.
Upper and Lower Plastic Side Vent
(No. 3316941.xxx)
19
13-3/4"
21-9/16"
Cutout
➤ Place the frame into the cutout.
➤ Secure the frame using sixteen #8 screws (not
provided) through the inside flange of the frame.
➤ Install the vent door into the frame using the lower
tabs as a guide.
➤ Lock the vent door into place by fully seating and
twisting the latches in the top corners of the vent
door.
Upper and Lower Plastic Side Vent
(No. 3317027.xxx)
20
28-5/8"
13-3/4"
Cutout
➤ Place the frame into the cutout.
➤ Secure the frame using sixteen #8 screws (not
provided) through the inside flange of the frame.
➤ Install the vent door into the frame using the lower
tabs as a guide.
➤ Lock the vent door into place by fully seating and
twisting the latches in the top corners of the vent
door.