What does E3 mean on my Dometic FJX4233M Air Conditioner display?
The error code E3 on your Dometic Air Conditioner display indicates a condenser coil temperature sensor fault. Contact an authorized service agent or Dometic for assistance.
Why does my Dometic Air Conditioner (FreshJet FJX4233EEH/ FJX4333E(EH)/FJX7333IHP/ FJX7337IHP/FJX7457IHP) constantly switch itself off?
If your Dometic FreshJet Air Conditioner constantly switches itself off, it may be because the icing sensor has tripped. This can occur if the outer temperature is too low or all air nozzles are closed.
Why does my Dometic FJX4233M constantly switch itself off?
If your Dometic Air Conditioner constantly switches itself off (fixed-speed and inverter models), the icing sensor may have tripped. This can occur if the outer temperature is too low or if all air nozzles are closed.
What to do if my Dometic Air Conditioner is not switching on?
If your Dometic Air Conditioner is not switching on, it could be due to the following reasons: * There is no power supply connected; check the power supply. * The voltage is too low (less than 200 V). * The voltage converter is defective. * One of the temperature sensors is defective. * The electrical fuse of the power supply is too low. For voltage issues, a defective voltage converter, a faulty temperature sensor, or an insufficient electrical fuse, contact an authorized service agent or Dometic.
What to do if my Dometic FJX4233M Air Conditioner (FreshJet FJX4233EEH/ FJX4333E(EH)/FJX7333IHP/ FJX7337IHP/FJX7457IHP) is not heating well?
If your Dometic FreshJet Air Conditioner is not heating well, it could be due to a few reasons: * The unit might not be set to heating; ensure it is. * The ambient temperature might be too low (below ? 2 °C), as the unit is designed for ambient temperatures above ? 2 °C. * The set temperature could be lower than the room temperature; select a higher temperature. * A temperature sensor or the evaporator fan might be defective. In this case, contact an authorized service agent or Dometic.
What does E0 mean on my Dometic FJX4233M display?
The error code E0 on your Dometic Air Conditioner display indicates a communication failure. Contact an authorized service agent or Dometic for assistance.
What does P7 mean on my Dometic Air Conditioner display?
The error code P7 on your Dometic Air Conditioner display indicates an evaporator coil protection issue (heating mode). Contact an authorized service agent or Dometic for assistance.
What does P9 mean on my Dometic Air Conditioner display?
The error code P9 on your Dometic Air Conditioner display indicates a compressor drive abnormality or that the compressor is not starting. Contact an authorized service agent or Dometic for assistance.
What does P0 mean on my Dometic FJX4233M Air Conditioner display?
The error code P0 on your Dometic Air Conditioner display indicates an over temperature or over current on the IPM module. Contact an authorized service agent or Dometic for assistance.
Why does water enter the vehicle from my Dometic FJX4233M?
Water may enter the vehicle from your Dometic Air Conditioner if: * The condensation water drainage openings are clogged. To resolve this, clean the water drainage openings. * The seals are damaged. If this is the case, contact an authorized service agent or Dometic.
General| Brand | Dometic |
|---|---|
| Model | FJX4233M |
| Category | Air Conditioner |
| Language | English |
To Next Page
