Dometic FlyTec FT200 Installing the flyscreen
11
•
The skirting board (5) needs the following space:
– There needs to be a space with a width of A = 18 mm between the outer edge
of the bodywork floor (4) and the edge of the interior fittings base (3).
– A space with a height of B = 3 mm and a depth of C = 15 mm needs to be
available from the edge of the interior fittings base (3).
You may need to adapt fitted cabinets (2) and the interior fittings base (3).
•
The flyscreen must be screwed directly to the sheet-metal bodywork at the top
and not just on the panelling or the interior fittings. It is usually sufficient to screw
it on to the base of the interior fittings.
➤ Measure the installation opening in your vehicle and check whether the
dimensions of the flyscreen fit your vehicle.
Trimming the opening (depending on the vehicle)
➤ If necessary, remove add-on parts that interfere (such as bottom end strips or
bodywork) in the installation opening.
To be able to install the skirting board (fig. 1 1, page 3) flush, you may need to trim
the existing fixtures (such as floors or cabinets).
➤ Mark the following (fig. 2, page 3):
– Size A = 18 mm (width of the bottom part of the skirting board), measured
from the edge of the sheet-metal bodywork
– Size B = 3 mm (height of the skirting board).
➤ If necessary, trim the existing fixtures with a suitable tool, such as an oscillating
saw.
➤ Smooth and clean the cut edges.
FT200-IO-16s.book Seite 11 Montag, 15. Januar 2018 2:19 14
To Next Page
Loading...
