HC302D, HC502D Installing and connecting the refrigerator
17
6 Installing and connecting the
refrigerator
6.1 Unpacking the refrigerator
➤ Check that the packaging is not damaged.
➤ Remove the cardboard packaging.
➤ Check that the refrigerator is not damaged.
If you find damage on the packaging or at the refrigerator resulting from
transport, report it immediately to the transportation firm.
6.2 Installing freestanding version
Observe the following instructions when installing:
• Install the refrigerator so that the warm air produced can easily flow away, either
upwards or to the sides.
➤ Place the refrigerator at the chosen place.
➤ Leave the refrigerator to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
HC302D-502D-IO-WEST.book Seite 17 Freitag, 17. März 2017 2:15 14
To Next Page
Loading...
