Dometic HC302D - Power Supply Connection; Door Handle Installation and Removal

EN
HC302D, HC502D Installing and connecting the refrigerator
19
6.4 Connecting the refrigerator to the power supply
A
➤ Connect the plug of the connection cable into the mains.
✓ The green power LED lights up (fig. 2 2, page 4).
➤ Press the button.
✓ The display turns on.
For the first two seconds the display will not show temperature values; it shows
“--.-”. Then the temperature read from the sensor is shown.
6.5 Mounting and removing the door handle
➤ Mount the handle as shown (fig. 7, page 6).
➤ Remove the handle as shown (fig. 8, page 7).
NOTICE!
• Connect the device to a separate circuit to prevent malfunctioning
due to problems with other electrical equipment. Never connect the
device to a single socket with other electrical equipment by means
of a multi-socket.
• UK only: The refrigerator is supplied with a plug fitted with 3 A fuse.
In case this fuse has to be to changed, a 3 A ASTA approved
(BS 1362) fuse must be used.
HC302D-502D-IO-WEST.book Seite 19 Freitag, 17. März 2017 2:15 14