15
Operation
4.0 Operating instructions
Before operating the miniBar, we recommend you
clean it both inside and outside.
Use a soft cloth, lukewarm water and a mild
detergent.
Following this, wash out the miniBar using
clean water and dry thoroughly.
At annual intervals, remove dust from fridge
aggregate using a brush or
soft cloth.
4.1 Cleaning
The device must be plugged into a properly
earthed socket.
The miniBar starts automatically with a self
test. If the electronics do not detect any
fault, the LED for the interior lighting illumina
tes for 2 seconds after approximately 10
seconds.
If a fault is detected, the illumination changes
to a continuous flashing light.
If this occurs, please consult your authorised
Customer Service
The miniBar achieves its operating tempera-
ture after several hours.
4.2 Initial operation
To prevent material damage :
Do not use soap or detergents which are
harsh, coarse or which contain soda .
Keep the door seal free from oil and
grease.
The cylinder locks have been lubricated
in the factory to be long-lasting.
CAUTION!
The miniBar is equipped with completely auto-
matic, electronic temperature control. Using an
optional remote control, the default setting can
be changed from 5 °C to 3 °C, 7 °C or 12 °C
(maximum ambient temperature 25 °C).
4.3 Temperature control
The energy-saving effect is highest when the
12°C preset is selected (internal temperature
range 8 °C to 14 °C).
If you select a lower (colder) temperature setting,
the energy consumption increases.
Observe the instructions in "
1.9.2 Energy-saving
tips
".
1
2
The miniBar is not suitable for storing peris-
hable foodstuffs.
WARNING!
Fig. 30
Yellow
Change over :
3°C
7°C
Blue
Change over :
5°C
12°C
3°C
(3x flashing)
5°C
(5x flashing)
7°C
(7x flashing)
12°C
(12x flashing)
To Next Page
Loading...
