Need help?Do you have a question about the Dometic i7800 and is the answer not in the manual?
General| Brand | Dometic |
|---|---|
| Model | i7800 |
| Category | Boating Equipment |
| Language | English |
Details safety labels on i7X00 actuators and their meanings, highlighting potential hazards.
Explains the i7X00 electromechanical shift and throttle system and its main components.
Illustrates system configurations for triple, dual, and single station setups with diagrams.
Crucial pre-installation advice and contact details for technical assistance from Dometic.
Guidance on mounting the control head and connecting optional trim/tilt switches.
Instructions for locating, mounting, and connecting mechanical cables to the shift/throttle actuators.
Details on power, start-in-gear protection, and ignition source wiring for system operation.
Procedures for connecting the CAN2 network harness for multi-station configurations.
Instructions on connecting the analog tachometer lead for RPM input if needed.
Steps to configure actuators, including type, instance, and parameter settings via CANtrak.
How to adjust control head parameters for optimal system performance using CANtrak.
Procedure to verify correct gear engagement and neutral return during the sea trial.
How to test and verify throttle response, including WOT and idle settings.
Adjusting control head features like lever friction and shift detents for user comfort.
Final checks and securing of components after completing the sea trial.
Explains system fault types (Danger, Warning) and their indications on the control head.
Outlines the terms and conditions of the 2-year limited warranty for SeaStar products.
Instructions and contact for returning products under warranty.
Provides contact information for Dometic technical support for assistance.
Mounting template for the dual lever control head, including dimensions.
Mounting template for the single lever control head, including dimensions.
Detailed dimensional drawings of the AC7700 actuator for installation planning.
Dimensional drawings of the single lever interface for reference.
Guide to using the CANtrak display's interface, buttons, and navigation features.
Covers the initial startup process, warnings, and system inspection for the CANtrak.
Instructions on accessing the dealer menu via a PIN code for advanced settings.
An overview of the CANtrak's menu system, including initial setup and settings.
Essential setup steps for new users of the CANtrak service tool for i7X00 systems.
Lists the required hardware and software for setting up the i7X00 system using Datalink.
Step-by-step guide for connecting the Datalink software to the i7X00 system via CAN2.
How to navigate the Datalink software interface and workspace to access system settings.
Detailed procedure for configuring actuators using Datalink, including type and instance settings.
Guide on configuring control head parameters and settings using the Datalink software.
How to check the current firmware version of system components using Datalink.
Instructions for updating firmware on actuators and control heads via Datalink.
Steps to update the CANtrak display software using a USB drive.
To Next Page
