Using the safe MD310, MD390, MD450
12
Changing the master code
A
You can change the factory setting code (888888). The safe must be opened for
this.
➤ Enter the correct six digit master code.
➤ Press the CLEAR button.
✓ The display shows the message NEW.
➤ Enter a new six digit master code.
➤ Press the CLOSE button.
✓ The display shows the message AGAIN.
➤ Repeat the entry of the new six digit master code.
➤ Press the CLOSE button again.
✓ The safe confirms the change of the master code with the message DONE.
NOTICE!
• If you forget your master code, nobody can access the safe any more
(not even the manufacturer). No resetting, or similar action, is
possible.
• Therefore note down the master code and store it very carefully in a
safe location.
• The safe has a factory setting code. We strongly recommend that you
change this code for security reasons.
PIN 6X
PIN 6X
CLEAR
NEW
PIN 6X
AGAIN
CLOSE
CLOSE
XSafe-MB.book Seite 12 Freitag, 16. September 2016 1:53 13
To Next Page
Loading...
