EasyManua.ls Logo

Dometic miniBar RH 440LD - Check list and customer service

Dometic miniBar RH 440LD
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
In the event of a fault developing, contact your
nearest Service Centre-see local telephone
directory.
An authorised service technician can check whether
this has been triggered or not.
(Details of the model, product- and serialnumber
are to be found on the data label in the top left of
the inside compartment.)
If after checking all the above points, the
refrigerator is still not working satisfactorily, contact
your nearest service engineer. State the problem,
model, product- and serial-number.
8
Figure 8.
Figure 9.
Figure 10.
Before you call a service engineer, carry out the
tests as described in the check list:
Failure : No cooling (the cooling unit at the back
of the device is cold).
Possible Cause Self Help Authorised
Service
a.) The device plug
is not plugged
b.) No voltage in
in.
socket.
c.) The electronics
or the sensor is
faulty.
e.) The device is in
its defrosting
phase.
b.) Check main fuse.
instruction 8.
plug.
a.) Plug in device
e.) See operating
c.) Install new
heating element.
electronics or
sensor.
d.) Install new
Failure : No cooling (the cooling unit is warm).
Possible Cause Self Help Authorised
Service
not level.
Leakage test ?
on a short while
cooling unit.
ago.
a.) The device is
b.) The device was
only switched
c.) Defective
using a spirit
level.
run for 5-6
device.
hours.
b.) Switch on the
device and let it
c.) Exchange
a.) Level the device
Failure : Poor cooling performance.
Possible Cause Self Help Authorised
Service
ventilated.
exposed to
direct sunlight.
tightly
while ago.
b.) Follow installation
a.) The cooling
unit is
not sufficiently
b.) The device is
c.) The fridge door
does not close
d.) The fridge was
stocked a short
a.) Check that the
are not covered.
ventilation grids
installed properly
Check that
device has been
instruction 4).
(installation
instruction 4).
in line 4.
c.) Check installation
d.) Check fridge after
5-6 hours for
proper cooling
function.
c.) Install new
doorseal,if
necessary.
Failure : Frost formation in fridge.
Possible Cause Self Help Authorised
Service
tightly.
a.) The fridge door
does not close
a.) Check installation
is in line with 4.
if necessary.
doorseal,
a.) Install new
2/-5 63=> +8. -?=>97/<
U
This refrigerator is equipped with a CU C system.
@
=/< 3-/
d.) The heating
element is faulty

Related product manuals