5
min 70 mm
min 30 cm
O I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
O I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
min 70 mm
O
I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
min 70 mm
min 30 cm
O
I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
O
I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
m
in 70 mm
O
I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
min 70 mm
min 30 cm
O
I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
O
I
P
OWER FAIL
E
NTER
A
LARM TEST
A
LARM HISTORY
min 70 mm
O I
P
OWER FAIL
E
NTER
ALARM TEST
A
LARM HISTORY
• The air must be allowed to circulate freely all
round the unit as good air circulation is essential
for trouble-free operation. There must always be
a gap of at least 70mm all round the unit. Upright
units must always be at least 30cm away from
the ceiling.
• Do not locate the unit below a ceiling fan or right
next to air-conditioning equipment.
• Two spacers are included with some models.
These must be attached to the rear of the unit as
shown in the diagram, before positioning the unit
against the wall.
Cleaning / Disinfection
• Clean or disinfect the unit inside and outside
before using it. Use only gentle cleaning agents.
Never use aggressive or caustic cleaning agents,
scouring powder, steel wool, abrasive sponges or
chemical solvents.
• For disinfecting, we recommend all the surface
disinfecting agents commonly used by the
customer, provided they are recommended by the
German Association for Hygiene and Microbiology
(DGHM) or other national organisations. For
disinfecting small areas, we recommend using a
concentrated alcoholic agent.
Installation
Location
• The unit must be set up in a dry well-ventilated place. Avoid direct
sunlight or locating it close to a heat source.
• Ensure that the unit is steady and perfectly straight and does not knock
against any of the units next to it.
Electrical Connection
• Before connecting the unit and switching it on for
the first time, allow it to stand for 30 minutes.
• Before connecting the unit, check whether the
details on the nameplate in the interior
correspond to local values.
•
The unit must only be connected to an earthed
socket, secured by protective earth conductor
and adequate fault-current circuit breaker.
• To prevent problems with other electrical
equipment causing this unit to malfunction, it
should be connected to a separate circuit. Never
connect the unit to a single socket with other
electrical equipment by means of a multi-socket.
• Make sure that the plug of the unit is easily
accessible so that if need be it can be easily
disconnected without having to move other
equipment or furniture.
To Next Page
Loading...
Need help?
General
